Návod na použitie ACER TRAVELMATE 4740

[. . . ] Always insist on genuine spare parts. These warnings are provided in the interest of safety. You MUST read them carefully before installing or using the appliance. During Operation It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred, always ensure that the book is left with the appliance in order that the new owner can get to know the functions of the appliance and the relevant warnings. This appliance has been designed for non professional purpose in private houses only. [. . . ] C) to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted. Then, check the flame is regular and adjust it as required. If you cannot light the flame even after several attempts, check the "cap" (Fig. To put the flame out, turn the knob to the symbol l. Always turn the flame down or put it out before taking the pans off the burner. A - Burner cap B - Ignition candle C - Thermocouple Using the hob correctly To ensure maximum burner efficiency, it is strongly recommended that you use only pots and pans with a bottom fitting the size of the burner used, so that flame will not spread beyond the bottom of the vessel. It is also advisable, as soon as a liquid starts boiling, to turn down the flame so that it will barely keep the liquid simmering. Use only pans or pots with flat bottom. . Carefully supervise cookings with fats or oil, since these types of foodstuff can result in a fire, if over-heated. Burner Big (rapid) Medium (semirapid) Small (Auxiliary) minimum diameter 160 mm. 160 mm. 13 Cleaning and Maintenance Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. General cleaning Wash the enamelled components with warm soapy water. Never use abrasive cleaners Frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food. IMPORTANT - To ensure a correct operation, a saving of energy and the long-life of the appliance, the voltage pressure of the appliance must correspond to the recommended values. The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut GJ 1/2". Interpose the sealing between the components as shown in fig. Screw the parts without forcing, adjust the connection in the required direction and tighten everything. IMPORTANT - When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation. Use some soapy water, never a flame. A) Ramp with ending nut B) Seal C) Adjustable connection FO 0264 Fig. 4 15 Electrical Connection The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the rating label); 2) check that the power supply is properly earthed in compliance with the current rules; 3) check the socket or the double pole switch used for the electrical connection can be easily reached with the appliance built in the forniture unit. The appliance is supplied with a connection cable. This has to be provided with a proper plug, able to support the load marked on the identification plate. [. . . ] 7 FO 0392 Adjustment of minimum level F To adjust the minimum level of the burners, proceed as follows: Light the burner. With a thin screwdriver, adjust the by-pass screw (see Fig. If changing from natural gas to LPG, completely tighten clockwise the screw, until a small regular flame is obtained. If changing from LPG to natural gas unscrew about 1/4 turn the bypass screw, until a small regular flame is obtained. [. . . ]